Skip to content

PARKER A1 WIPER SEAL

    A1 – wiper seal

    Descriptions

    The purpose of the profile A1 wiper ring is to prevent dust, dirt, grains of sand and metal swarf from penetrating. This is achieved by a special design which largely prevents the development of scratches, protects the guiding parts and extends the working life of the seals.
    Oversized diameters ensure a tight fit in the groove thus preventing the penetration of foreign particles and dampness.
    The profile A1 wiper ring provides a technically accurate closure at the cylinder; no screwrings and brackets are required. No close tolerances are necessary and no metal inserts. The corrosion which may occur with metal-cased wipers will be prevented.
    For the groove close tolerances are not required.
    If minor quantities or other diameters are required, these may be cut from the next largest size having the same cross-section.

    Features

    • Good wear resistance.
    • High temperature resistance in case of suitable compound selection.
    • Excellent media resistance in case of suitable compound selection.
    • Suitable compounds available for special requirements of the chemical process industry.
    • Suitable compounds available for special requirements of the food processing industry.
    • Product geometry prevents dirt deposits at the front face of the cylinder.
    • Installation in closed and undercut housings.

    Range of application

    The profile A1 wiper ring is designed for axially operated rods in hydraulic and pneumatic cylinders, plungers and rod-guidances.

    Operating temperature -35 °C to +100 °C
    Sliding speed ≤ 2 m/s

    Installation

    The profile A1 wiper ring is supplied as a continuous ring. Any pressure on the back of the ring should be avoided. Intermediate sizes may easily be cut from the next largest ring with the same cross-section. The ring is to be cut at an angle of 90° to the new circumference length (+ 2 to 3 % in excess). Due to the excess length the two ends will fit closely together so that no gap will occur. Gluing is not necessary. The wiper can easily be pressed into the groove and will fit perfectly tight.

    Sizelist

    dDHLan
    12207411
    14227411
    16247411
    18267411
    20287411
    22307411
    25337411
    28367411
    30387411
    32407411
    35437411
    36447411
    38467411
    40487411
    42507411
    45537411
    48567411
    50587411
    5062105.51.51.5
    55637411
    56647411
    60687411
    62707411
    63717411
    65737411
    70787411
    7082105.51.51.5
    75837411
    78867411
    80887411
    8092105.51.51.5
    85937411
    90987411
    951037411
    971057411
    1001087411
    105117105.51.51.5
    110122105.51.51.5
    120132105.51.51.5
    125137105.51.51.5
    128140105.51.51.5
    130142105.51.51.5
    140152105.51.51.5
    145157105.51.51.5
    150162105.51.51.5
    160172105.51.51.5
    170182105.51.51.5
    180192105.51.51.5
    190202105.51.51.5
    200212105.51.51.5
    220235136.522
    230245136.522
    240255136.522
    260275136.522
    275290136.522
    325340136.522