Skip to content

PARKER V6 PNEUMATIC SEAL

    Pneumatic Seal V6

    The profile V6 pneumatic cushioning seal is specially designed for cushioning pistons in pneumatic cylinders.

    • No mechanical check valves required since their function is performed by the cushioning rings.
    • Optimum use of design-related cushion travel.
    • Immediate response to reversed direction thanks to incorporated venting channels.
    • Good wear resistance.
    • Easier installation.
    • High temperature resistance in case of suitable compound selection.
    • Excellent media resistance in case of suitable compound selection.
    • Short axial assembly length.
    • Short radial assembly depth.
    • Installation in closed and undercut housings.

    Range of application
    For pneumatic cylinders with end-position cushioning
    Operating pressure≤ 16 bar 1)
    Operating temperature-30 °C to +80 °C
    Sliding speed≤ 1 m/s
    MediaCompressed air, both lubricated and oi
    free (after greasing for fitting)

    Installation
    For the cushioning spear (Ø d) we recommend a surface finish of Rt = 2 to 3 µm with flattened or polished process traces. The groove bottom (Ø DH11) should not exceed surface finish of Rt = 10 µm with flattened or polished traces.

    d,S,D,D1,D2,R,L,
    1041810.51234.8
    1242012.51434.8
    1442214.51634.8
    1642416.51834.8
    1842618.52034.8
    2042820.52234.8
    2243022.52434.8
    2443224.52634.8
    2543325.52734.8
    2653626.62846
    2853828.63046
    3054030.63246
    3254232.63446
    3454434.63646
    3554535.63746
    3654636.63846
    3854838.64046
    4055040.64246
    4555545.64746
    5056050.65246
    5576955.65858.4
    6077460.66358.4
    6577965.66858.4
    7078470.67358.4
    8079480.68358.4
    1007114100.610358.4
    1107124110.611358.4